PIPEMAN’S HAND HELD ECO DIGITAL MULTIMETER | IS-9000-ECO

Test for NCV/ Continuity

NCV:

1. Keep pushing the NCV button to enter the NCV mode.
2. Hold the product and move it around, the built-in beeper will beep when the inner sensor detects AC voltage nearby. The stronger the voltage is, the quicker the beeper beeps while the central LED light will twinkle.

Continuity:

1. Put the red lead into the VΩ terminal, put the black lead to the COM terminal
2. The continuity measure will be auto matched.
3. Touch the probes to the desired test points of the circuit.
4. The built -in beeper will beep when the resistance is lower than 50Ω, which indicates a short circuit while the central LED light will light .

Test for Current

1. Put the red lead to A mA terminal and put the black lead to COM terminal. The current measure will be auto matched when you put the leads in.
2. Touch the probes to the correct test points of the circuit to measure the current.
3. Read the measured current on the display
4. When you input the current over 2 AMP, the testing time should be less than 3 seconds.
5. When the probes are in the current terminal but you have no operations, this product will alarm each 4 seconds to remind that you are in the current mode

Measure DC/AC Voltage (＞0.8mV)

1. Only when the voltage is higher than 0.8mV, this product will show the display.
2. Put the red lead into the VΩ terminal, put the black lead to the COM terminal.
3. The DC or AC voltage will be auto matched.
4. Touch the probes to the correct test points of the circuit to measure the voltage.
5. Read the measured voltage on the display.

Measure Resistance

1. Put the red lead into the VΩ terminal, put the black lead to the COM terminal.
2. The resistance measure will be auto matched.
3. Touch the probes to the desired test points of the circuit to measure the resistance.
4. Read the measured resistance on the display.